This is the successor model to the 23-24 photochromic goggles.
Approximately 207g
☆Double lens☆Interchangeable lenses (replacement lenses sold separately)
☆OTG (glasses compatible)
☆Magnetic closure
☆Asian fit
☆REVO mirror
☆Polarized lenses
☆Flat lenses
☆UV protection
☆Interchangeable bands (sold separately)
☆Anti-fog coating *The band and lens can be interchanged with the “23-24 Photochromic Goggles”.
[Full UV protection]
The REVO mirror coating cuts out the glare from the snow surface, protecting your eyes while maintaining sufficient brightness for visibility.
[Flat lens]
It has minimal distortion and provides a natural view similar to that of the naked eye, ensuring a wide and bright field of view.
[OTG] Compatible with eyeglass frames up to 14cm wide.
[Less likely to fog up]
The double lens design prevents fogging by creating an insulating layer of air between the lenses, eliminating the temperature difference between inside and outside.
[Ventilation]
Warm air from the insulating layer is slowly drawn out through the vents, creating an air flow that reduces fogging.
[Anti-fog coating]
A special coating on the inside of the lens shakes off small droplets of water that form due to temperature differences.
[Thin frame]
The thickness has been reduced compared to the previous model, making your face look even smaller when worn! The thickness is 2-2.7cm (excluding the sponge part).
[Magnetic lens & side lock]
Seven strong magnets and a side lock hold the lens securely in place, preventing it from falling out.
[Asian fit]
The three-layer sponge foam gently seals the gap between the mask and your face for a comfortable fit. The nose area is thicker than the previous model, making it even more suitable for Asian faces!
※Please note 1※
Do not wear goggles on your forehead or anywhere else where moisture can be easily absorbed. Holding goggles up on your forehead allows moisture from sweat to be drawn into the insulating layer through the ventilation holes, causing fogging.
※Caution 2※
Before each use, be sure to allow the space between the two lens layers to dry completely. For example, when packed on flat ground with a humidity of approximately 80%, the humidity of the insulation layer will be 80%. If you take these goggles out of the pack at a ski resort where the humidity is around 40%, isolated from the outside air, the air in the insulation layer will be exposed to cold, dry air, causing fogging. To prevent fogging when wearing the goggles, you should remove the goggles and allow the moisture in the insulation layer to dry before putting them on.
*Please note that when drying, hot air may cause deformation of the lens.
*It will take approximately one week from the shipping notification to delivery.
*Please make sure that your settings allow you to receive emails from [hello@stores.jp] and [taotech528@gmal.com].